![asymtek automove 201 programming manual asymtek automove 201 programming manual](https://i.ebayimg.com/images/g/AFkAAOSwZv5gz065/s-l300.jpg)
![asymtek automove 201 programming manual asymtek automove 201 programming manual](https://entlasopa920.weebly.com/uploads/1/2/6/4/126481053/850819233.jpg)
#Asymtek automove 201 programming manual driver#
The original installation seems to have a power unit, a computer unit and a driver board, Without going up to the workshop and removing the head i dont know for sure but.įrom looking at the control boards i assume its all stepper's Has anyone done a retro fit or can you point me in the direction of someone who has.
#Asymtek automove 201 programming manual drivers#
So i have decided to buy a Arduino Mega, a Ramps 1.4 and the matching 5 small stepper drivers as a all in one (well 7) ready built unit and want to use that to control the Stratasys, and thats were i get to, now ive built my own cnc machines sucessfully so i have a good basic knowledge and the ability to figure it out eventually too but im getting older and tired!!! But now it has stopped working, weve lost communications with it from our PC, tried different cables and decided it must be the onboard controller, the machine still works from the keypad and moves by manual controls, the display comes up with "memory error" but the manual says this is that the machine has lost one or more of its preset values which can be set via the keypad. Iva got a Stratasys 8000 fdm machine aquired some years ago from a business closure auction, and have used it intermittentley over the past 5 years.
![asymtek automove 201 programming manual asymtek automove 201 programming manual](https://www.artisantg.com/itemimages/Asymtek_Controller_187717_View3.jpg)
Well ive spent quiet a few hours googeling and not found a starting point never mind an answer!